156
Driving and operating
Starting the vehicle at low
temperatures
Starting the engine without additional
heaters is possible down to -25 °С for
diesel engines and -30 °C for petrol
engines. Required is an engine oil
with the correct viscosity, the correct
fuel, performed services and a
sufficiently charged vehicle battery.
With temperatures below -30 °C the
automatic transmission requires a
warming phase of approx. 5 minutes.
The selector lever must be in position
P.
Turbo engine warm-up
Upon start-up, engine available
torque may be limited for a short time,
especially when the engine
temperature is cold. The limitation is
to allow the lubrication system to fully
protect the engine.
Overrun cut-off
The fuel supply is automatically cut off
during overrun, i.e. when the vehicle
is driven with a gear engaged but
accelerator pedal is released.
Depending on driving conditions, the
overrun cut-off may be deactivated.
Stop-start system
The stop-start system helps to save
fuel and to reduce the exhaust
emissions. When conditions allow, it
switches off the engine as soon as the
vehicle is at a low speed or at a
standstill, e.g. at a traffic light or in a
traffic jam.
Activation
The stop-start system is available as
soon as the engine is started, the
vehicle starts-off and the conditions
as stated below in this section are
fulfilled.
Without touchscreen
The system is ready to operate when
the LED in the button
D
is not
illuminated. To activate the system
when the system is deactivated,
press
D
. If the stop-start system is
temporarily not available and the
button
D
is pressed, the LED in the
button flashes.
With touchscreen
The system can be activated in the
vehicle personalisation
stop-start system is temporarily not
available, the control indicator
D
flashes for a few seconds.
Deactivation
Without touchscreen
Press
D
to deactivate the stop-start
system. The deactivation is indicated
when the LED in the button
illuminates.
Summary of Contents for Vivaro C
