1 2 3 4 5 6
4. Bedienung
4.1. Lamp power setting
The
Strobe Xenon 3000DMX
has two operation modes:
High power:
maximum intensity
Low power:
reduces output and extends lamp life
The mode is set with Pin 6 at the Mode Dip-Switch.
High power
Low power
4.2. Compatible lamps
For the
Strobe Xenon 3000DMX
are two different lamp available: the XOP 7-OF and the XOP 15-OF.
The XOP 7 operates on voltages from 90V to 260V and is recommended for use with the main
suppliers under 200V. The XOP 15 operates on voltages from 125V to 260V and is recommended for
use with mains suppliers over 200V.
Installing any other lamp may create a safety hazard or damage the fixture!
4.3. DMX modes
The DMX modes are selected with the Mode Dip-Switch. .
With mode 1 (1 channel) you can control the
Strobe Xenon 3000DMX
with one
channel. You can control the flash rate.
With mode 2 (3 channels) you can control intensity, flash duration and flash rate.
With mode 3 (4 channels) you can control intesity, flash duration, flash rate and six
special effects.
4.4. Setting the DMX address
The start address is the first channel, which gets the control signals from a controller. It can be set
from 1-511. To control every device on ist own, every device needs ist own address. It is not allowed
that an address overlaps another.
Set the DMX address as shown in the chart below. 0 means the pin is set to OFF, 1 means the pin is
set to ON. Pin 10 has to be set OFF for DMX operating.
DIP Switch
0=OFF, 1=ON
#
9
0
0
0
0
0
0
0
0
1
1
1
1
1
1
1
1
#
8
0
0
0
0
1
1
1
1
0
0
0
0
1
1
1
1
#
7
0
0
1
1
0
0
1
1
0
0
1
1
0
0
1
1
1 2 3 4 5 6
1 2 3 4 5 6
8 / 16
