136
Subject to modification! Updated 12/2017
If everything is all right, then:
place the hood over the mounting plate at an angle of 45°,
lower the hood carefully until it rests against the back of the
mounting plate,
connect the earth cable between the hood and battery
inverter,
check the electrical connection between the hood and
central earthing point by means of a continuity test,
swivel the hood towards the unit while paying attention to
the position of the On/Off switch
o
Make sure that no cables are pinched!
o
The spring must engage audibly!
secure the energy storage system with the three supplied
screws on the bottom.
Checking the operating state
11.5.1
Check whether the fuses have been re-connected.
Switch on the energy storage system using the
On/Off
button. The button will be locked in the lower position.
Figure 33: On/Off button with LED ring