POWX230
EN
Copyright © 2021 VARO
P a g e
|
5
www.varo.com
If devices are provided for the connection of dust extraction and collection facilities, ensure
these are connected and properly used. Use of these devices can reduce dust related
hazards.
5.4
Power tool use and care
Do not force the power tool. Use the correct power tool for your application. The correct
power tool will do the job better and safer at the rate for which it was designed.
Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
Disconnect the plug from the power source before making any adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
Store idle power tools out of the reach of children and do not allow persons unfamiliar with
the power tool or these instructions to operate the power tool. Power tools are dangerous
in the hands of untrained users.
Maintain power tools. Check for misalignment or sticking of moving parts, breakage of
parts and any other condition that may affect the power tool’s operation. If damaged, have
the power tool repaired before use. Many accidents are caused by poorly maintained
power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to stick and are easier to control.
Use the power tool, accessories and tool bits etc., in accordance with these instructions
and in the manner intended for the particular type of power tool, taking into account the
working conditions and the work to be performed. Use of the power tool for operations
different from intended could lead to a hazardous situation.
5.5
Service
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
6 ADDITIONAL SAFETY INSTRUCTIONS FOR TILE CUTTERS
Make sure that the cutting disc is correctly screened by the guard.
Never remove the riving knife. The distance between the cutting disc and the riving knife
should not exceed 5 mm.
Do not use cutting discs which are bent, deformed or otherwise damaged.
Do not use cutting discs which do not comply with the specifications stated in this manual.
Never start cutting tiles before the machine reaches full speed.
Never attempt to cut extremely small workpieces.
Do not leave the work area until the machine has been switched off and the cutting disc
has come to a complete standstill.
Never attempt to stop the cutting disc by exerting pressure on the side of the disc.
Always unplug the machine before performing any maintenance.
Do not use the machine before it has been completely assembled and installed according
to the instructions.
Do not perform any design, assembly or Construction activities on the table while the
machine is switched on.
Unplug the machine and clean the table before leaving the work area.
6.1
Power supply
This tile saw must be connected to an earthed 230V - 50Hz power source.
This power source must be secured by a 16A fuse.
Your machine is supplied with a 30mA residual current device to protect the user against
electric shock.