POWX1415
EN
Copyright © 2017 VARO
P a g e
|
5
www.varo.com
Insert the saw blade into the chuck to the deepest position and release the clamp to lock
the blade in position.
Pull on the blade to ensure it’s securely fastened.
Note: Do not operate the reciprocating saw if the adjustable shoe is not
installed.
Before plugging in power cord, always pull on the blade (6) to make sure it
is securely locked in the clamp. Failure to do so may result in serious
injury.
8 OPERATION
8.1
Switch on/off (3)
Connect the plug to the power supply.
Turn on or turn off the tool by squeezing or releasing the ON/OFF switch trigger (3).
For continuous operation just press the lock-on button (4) on the left side of the handle.
The lock-on button can be release by pressing the switch trigger again.
8.2
General cutting
Make sure the saw blade is clear of any foreign material and the power cord or extension
cord are out of the path of the blade.
Be sure the material to be cut is held firmly. Small work pieces should be securely
clamped in a vise or clamped to the work bench.
Make out a cutting line.
Hold the saw firmly in front and clearly away from you.
Switch on the tool and wait until the saw has reached its full speed.
Place the shoe on the work piece and begin to saw.
NOTE: Use only enough pressure to keep the saw cutting. Allow the blade
and the saw to do the work.
WARNING! Make sure the saw blade does not touch the work piece until the
saw reaches its maximum speed. Failure to do so would causes loss of
control and result in serious injury.
WARNING! Use of excessive pressure that causes bending or twisting of
the blade may cause the blade to break.
8.3
Metal cutting
Blades specifically designated for cutting metals must be used for this
purpose.
When cutting metal material such as sheet steel, pipe, steel rods, aluminum, brass and
copper etc., be careful not to bend or twist the blade and do not force the cutting action.
It’s recommended that you use cutting oil to lubricate the cutting surface to avoid the blade
from overheating. Following the general cutting procedure as described above.
