POWEG4010
EN
Copyright © 2017 VARO
P a g e
|
6
www.varo.com
Caution! Metal obstacles like fences etc. may damaged the cutting blades.
Always make sure to keep the extension cord behind your back and to start cutting the
hedge at the point nearest to the supply socked. Therefore plan your working direction
before staring.
8.3
Power Cord
To prevent the power cord from disconnecting from the hedge trimmer, loop the cord
around the recessed hook and pull gently to tighten.
9 CLEANING AND MAINTENANCE
Warning! Before performing any work on the equipment, pull the power
plug.
Check your machine regularly before starting the work.
Damaged cutting blades have to be repaired or exchanged by a qualified service man
before working with the machine
After each cutting operation, clean the cutting blade with a soft brush and cloth with
lubricating fluid oil and spray a thin layer of fluid protective oil on the completes blade.
Always keep the ventilation slots in motor housing clean
Never clean or spray a machine with water .clean the motor housing only with a moist
cloth and never apply detergents or solvents! These could ruin the plastic parts of the
machine ,Finally, dry the motor housing carefully.
Stock the machine with the knife protection.
Only use original accessories and spare parts.
10 TECHNICAL DATA
Type
POWEG4010
Voltage / frequency
220-240V~ 50Hz
Power input
520W
Blade length
550 mm
Cutting length
510 mm
Cutting capacity
16 mm
No load speed
1750 min-1
11 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
88 dB(A)
Acoustic power level LwA
104 dB(A)
ATTENTION!
Wear
hearing
protection
when
sound
pressure
is
over 85 dB(A).
aw (Vibration)
4,2 m/s²
K = 1,5 m/s²
12 SERVICE DEPARTMENT
Damaged switches must be replaced by our after-sales service department.
If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
