POW63771
EN
Copyright © 2016 VARO
P a g e
|
8
www.varo.com
Only use the recommended blades and spare parts by the manufacturer. The use of non-
genuine parts can damage the machine and injure the operators. Keep the lawnmower in
good working condition.
If the blade stopping device do
esn’t work, please contact service center for help.
Warning: Do not touch rotating blade.
Warning: Refuel in a well ventilated area with the engine stopped.
6
SAFETY WARNINGS GASOLINE
WARNING: Use extra care in handling fuels. They are flammable and the
vapours are explosive. The following points must be observed.
Use only an approved container.
Never remove the fuel cap or add fuel with the power source running. Allow engine
exhaust components to cool before refueling.
Do not smoke.
Never refuel the machine indoors.
Never store the machine or fuel containers inside, where is an open flame, such as a
water heater.
If fuel is spilled, do not attempt to start the power source, but move the machine away
from the area of spillage before starting.
Always replace and securely tighten the fuel cap after refueling.
If the tank is drained, this should be done outdoors.
7
ASSEMBLY
7.1
Folding handle
Fix the lower handlebars into the unit body with a suitable spanner. The nuts must always
point to the outside of the machine. (Fig. 1 a, Fig. 1b)
Release the upper handlebars for folding.
Connect the upper handle and the lower handle with the locking knob. The locking knobs
must always point to the outside of the machine. (Fig. 1c)
Attach the cable-clamp to the position shown and then attach the cable. Caution: Traction
and starter cables must always be positioned on top of the cross bar of the push handle.
This provides free movement of the cables on top of the lower section of the push handle,
when the handle is folded. (Fig. 1d, Fig. 1e). Incorrect mounting of these cables could
lead to damaging and/or straining them, resulting in a malfunction of the machine. In this
case the guaranty is void.
7.2
Mounting and dismounting the grass catch box/bag
To fit: Raise the rear cover and hitch the grass catch on rear of mower. (Fig. 2a, Fig. 2b,
Fig. 2c)
To remove: grasp and lift the rear cover, remove grass catch.
7.3
Starter handle
Move the starter handle from the engine to the rope guide. (Fig. 3)
7.4
Height of cut
Apply outward pressure to disengage lever from rack. Move lever forward or back to adjust
height. (Fig. 4)