POW6451
EN
Copyright © 2014 VARO
P a g e
|
8
www.varo.com
source or possible fire. Remember that operating the starting mechanism on engine
powered machines will still cause the cutting means to move
Keep all guards and deflectors in place and in good working condition
Do not tamper with the power source governor settings; the governor controls the safe
maximum operating speed and protects the power source and all moving parts from
damage caused by over speed. Seek authorized service if a problem exists.
Do not transport this machine while the power source is running
Shut off the power source and disconnect the spark plug lead (electric unit disconnect
from supply) whenever you leave the work area
Do not tilt the machine while the power source is running
6.3
Maintenance and storage
When the machine is stopped for servicing, inspection, or storage, or to change an
accessory, shut off the power source, disconnect the spark plug wire from the spark plug
(electric unit disconnect from supply), make sure that all moving parts have come to a
complete stop and, where a key is fitted remove. Allow the machine to cool before making
any inspections, adjustments, etc
Store the machine where fuel vapor will not reach an open flame or spark. For extended
storage periods, run the unit dry of fuel. Allow the machine to cool before storing.
When servicing the cutting means be aware that, even though the power source will not
start due to the interlock feature of the guard, the cutting means can still be moved by a
manual starting mechanism.
6.4
Additional safety instructions for units with bagging attachments
Shut-off the power unit before attaching or removing the bag.
7 ASSEMBLY INSTRUCTIONS
Warning! You may need assistance when lifting the machine out of the box
and assembling.
Open the package and remove the machine from package;
Pull out the collect box and take out the main part of the machine and all accessories;
7.1
Assembly of the shredder
Turn the shredder upside down.
Pivot the legs upward, place the supplied
wheel axle through the respective
openings.
Insert the screws through the black
plastic and screw tight.
Place the supplied sleeves on the wheel
axles. Then the wheels, the pinion and,
finally, the lock nut with the wheel cover.
