POW64122
EN
Copyright © 2013 VARO
P a g e
|
9
www.varo.com
Warning: never use straight gasoline in your unit. This will cause
permanent engine damage and void the manufacturer’s warranty for that
product. Never use a fuel mixture that has been stored for over 90 days.
Warning: 2-cycle lubricant must be a premium grade oil for 2-cycle air
cooled engines mixed at a 40:1 ratio. Do not use any 2-cycle oil product
with a recommended mixing ratio of 100:1. If insufficient lubrication is the
cause of engine damage, it voids the manufacturer’s engine warranty.
8.2
Mixing fuel
Add oil to an approved fuel container followed by the gasoline to allow incoming gasoline to
mix with oil. Shake container to ensure thorough mix.
Warning: Lack of lubrication voids engine warranty. Gasoline and oil must
be mixed at 40:1
8.2.1
Fuel and lubrication symbols
8.2.2
Mixing ratio: 40 parts gasoline to 1 part lubricant
Gasoline liters
1
2
3
4
5
2-cycle oil ml
25
50
75
100
125
8.2.3
Recommended fuels
Some conventional gasolines are being blended with oxygenates such as alcohol or an ether
compound to meet clean air standards. The engine is designed to operate satisfactorily on any
gasoline intended for automotive use including oxygenated gasolines.
8.2.4
Chain and bar lubrication
Always refill the chain oil tank each time the fuel tank is refilled. We recommend using our
replacement chain & bar. Always use good quality chain oil, which contains additives to
reduce friction and wear and to assist in the prevention of pitch formation on the bar and chain
9
OPERATION
9.1
Engine pre start checks (Fig 8)
WARNING: Never start or operate the saw unless the bar and chain are
properly installed.
Fill the fuel tank (A) with correct fuel mixture.
Fill the oil tank (B) with correct chain and bar oil...
40:1
