VAR-SOM-SOLO/DUAL based on
NXP’s i.MX6
Evaluation Kit Quick Start Guide
10
1
2
3
4
9
11
12
13
14
15
16
17
18
19
20
21
22
23
24
5
6
7
8
28
29
25
26
27
Evaluation Kit initial Setup
1.
Carefully remove the 7” LCD and VAR-SOLOCustomBoard board from the
package.
2.
Connect the 7” LCD Touch and Display cables to the Evaluation Kit connectors
J7,J15 respectively as shown in the upper left picture.
Note
:
Display cable connector pins 1,2 (colored in red) should be connected to
J15 pins 1, 2 respectively.
Touch cable
– connect cable with metal contacts facing down.
3. Plug the USB type A to micro B cable between the USB debug connector (J103)
and a PC USB port.
4.
Plug the wall adapter’s pin into the VAR-SOLOCustomBoard
5V power jack (J19) and to a 120VAC~240VAC power source.
Top side:
1. 5V DC In Jack (J19)
2. Boot select switch (SW6)
3. LVDS0 Header (Secondary Display)
4. RS232 Header
5. LVDS1 Header (Primary Display) (J15)
6. MIPI CSI-2 Camera [optional add-on]
7. JTAG Header
8. Capacitive Touch (J7)
9. VAR-SOM-SOLO/DUAL Connection
10. Headphones Out
11. Line In
12. Parallel Camera Header
13. HDMI
14. CAN Bus Header
15. USB0 Host
16. Miscellaneous Header
17. USB1 Host
18. I2C/SPI Header
19. 10/100/1000Mbps Ethernet
20. USER Button1
21. USER Button2
22. USER Button3
23. Reset Button
24. OFF/ON Switch (SW5)
Bottom side:
25. USB Debug (J103)
26. micro SD Card slot (J102)
27. RTC Battery Holder
28. USB0 OTG
29. Resistive Touch
