14
TriScroll 300 Dry Scroll Vacuum Pump
DRAF
T
2
/
10
/05
13. Secure the inboard housing assembly to the
frame using the four M5x15 screws.
14. Insert the tip seal in the scroll tip grooves on
the orbiting plate.
15. Cut the seal to the correct length at the end
of each groove. Leave a gap of 1/8" (3mm)
from the outer end to allow for thermal
growth.
16. Squeeze a dot of Krytox GPL 224 grease
into each of the three needle bearings.
17. Smear grease over the needles.
18. Coat the lips of all three seals with grease.
TriScroll 300 Reassembly (continued)