ProStar 325 UV-Vis Detector Control Manual
-
19 -
03-914947-44:2
Miscellaneous Control
Analog Control Group:
In the
Analog X Source
scrolling list, select Wavelength 1,
Wavelength 2, or none. These entries specify which signal will be
chosen for the two analog outputs on the rear panel of the
detector. Wavelength 2 is only useful if the detector is operating
in dual channel mode. The same signal can be output from the
two analog channels even if the detector is operating in single
wavelength mode.
In the
Analog X Peak Ticks
scrolling list, select enable or disable.
Peak Ticks
are small spikes added to the analog output to
indicate when the Peak relay is activated.
