Vari Lite VL6000 Beam Luminaire, User Manual

Page: 43 / 103

I
NSTALLATION
: I
NSTALLATION
P
ROCEDURES
2
02.9708.0002 27 April 2017 25
WARNING: Ensure that the bracket locking mechanism is fully seated after the bracket is installed
on the luminaire. AVERTISSEMENT: Assurez-vous que le mécanisme de support de verrouillage est
complètement inséré après le support est installé sur l'appareil.
Figure 2-9: Installing Brackets on Luminaire Enclosure
Installing in Truss:
Step 1. Using two people, lift luminaire into mounting position.
Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
wing bolt) is properly tightened and that luminaire is fully supported.
Step 3. Attach safety cable (as required) as follows (refer to Figure 2-10 on page 26 ):
a. Loop safety cable at least once around safety cable anchor point rod.
b. Loop safety cable at least once around truss/pipe and secure around pipe.
Press up to
Locked
install or release
Locking
Mechanism
Example Truss Hook and Mounting Hardware (not included, sold separately)
Mount
Bracket
Locking
Mechanism
Raised Mounting Buttons (8 each)
Keyed Hole
Mount Bracket*
Fit bracket’s keyed hole and locking mechanism
over raised mounting buttons and slide forward
to lock.
Brackets
Bracket
Orientation
Example Bracket
Orientations