54
9
$5,
/
,7(
9/9/%6
327
/
80,1$,5(
6
(59,&(
0
$18$/
0 2 . 9 6 3 8 . 0 0 1 0
C O N F I D E N T I A L
2 3 - A u g - 9 9
3DFNLQJ
To ensure that luminaires are not damaged during shipment, it is important
to properly pack in the case.
To pack VL6 luminaire:
Step 1. At console or Smart Repeater unit, run pack-up cue to place
luminaire in proper orientation for transport. (The pack-up cue
should drive lens assembly back into head and iris to half closed
position. Pan should be 180 degrees from stops and tilt halfway
between stops.)
Step 2. Disconnect luminaire input cable from system and remove
luminaire from truss or floor.
CAUTION: If allowed to hang freely in the case, the input cable connec-
tors can rest on the yoke leg covers of adjacent units. When the road case
cover is closed, the connectors will be pressed onto the yoke leg covers
causing damage to the covers or the connectors.
Step 3. Secure input cable and pack as follows:
a. Lower luminaire head first into road case. For luminaires
with truss hooks installed, route input cable under truss hook
uprights and orient the loop so that it faces toward the center
of the case.
Ensure all input cables
are tucked under hooks
and loops are toward
center of case
