Vari Lite VL3015, Service Manual

Page: 33 / 210

T
ESTING
: C
ALIBRATION
S
EQUENCE
- VL3515 S
POT
L
UMINAIRE
0 2 . 9 6 7 9 . 0 0 1 0 0 15
2
Calibration Sequence - VL3515 Spot Luminaire
Note: This calibration sequence is only for the VL3515 spot luminaire only. For the VL3015 spot
luminaire, refer to “Calibration Sequence - VL3015 Spot Luminaire” on page 14 .
The following is an outline of the luminaire’s standard calibration sequence:
Phase 1
• Tilt
• Strobe
• Rotating Shutter Assembly
• Color Wheel
Phase 2
• Dimmer
• Shutter Frame 1A
• Shutter Frame 1B
• Shutter Frame 2A
• Shutter Frame 2B
Phase 3
• Shutter Frame 3A
• Shutter Frame 3B
• Shutter Frame 4A
• Shutter Frame 4B
Phase 4
• Edge
• CTO
• Yellow
• Magenta
Phase 5
• Pan
• Zoom
• Cyan
Phase 6
• Index 1
• Rotating Gobo
• Fixed Gobo
Auto Recalibration
Most mechanisms with sensors will check their sensor when at a zero position, if the sensor is not
detected within 3 seconds, the mechanism will recalibrate. This applies to all except pan and tilt, and
zoom and edge. Pan and tilt are corrected continuously if required by encoders fitted to the motor
shaft.