![background image](http://html1.mh-extra.com/html/vari-lite/vl2000/vl2000_user-manual_3512493087.webp)
VARI
❋
LITE
®
- VL2000™ S
POT
L
UMINAIRE
U
SER
’
S
M
ANUAL
7 8
02-M ay- 03
0 2 . 9 6 7 3 . 0 0 0 1 D
Troubleshooting
Error Messages
If a problem occurs during luminaire calibration, at the end of the calibration sequence the Menu
Display will cycle through any applicable error message(s), one a time until the end of the list is
reached. To review the error messages again, it will be necessary to access them using the Status
function.
Refer to next page for a list of possible causes and remedies associated with the error messages.
To access error messages:
Step
1. Press [Menu].
Step
2. Press [Up] / [Down] arrows until
Fixt
(Fixture) appears. Press [Enter].
Step
3. Press [Up]/ [Down] arrows to access
STAT
. Press [Enter]. (Display will now scroll through
any error messages or display
OK
if no errors.)
Table A-1: Error Messages
Display
Message...
OK
No Errors Found
B1M1 / Whl2 / NoSn
Aux Board 1, Motor 1 / Wheel 2 / Sensor Not Found
B1M1 / Whl2 / SAct
Aux Board 1, Motor 1 / Wheel 2 / Sensor Always Active
B1M2 / Dimm / NoSn
Aux Board 1, Motor 2 / Dimmer / Sensor Not Found
B1M2 / Dimm / SAct
Aux Board 1, Motor 2 / Dimmer / Sensor Always Active
B1M3 / Whl1 / NoSn
Aux Board 1, Motor 3 / Wheel 1 / Sensor Not Found
B1M3 / Whl1 / SAct
Aux Board 1, Motor 3 / Wheel 1 / Sensor Always Active
B2M1 / Gobo / NoSn
Aux Board 2, Motor 1 / Rotating Gobo Wheel / Sensor Not Found
B2M1 / Gobo / SAct
Aux Board 2, Motor 1 / Rotating Gobo Wheel / Sensor Always Active
B2M2 / Indx / NoSn
Aux Board 2, Motor 2 / Rotating Gobo Index / Sensor Not Found
B2M2 / Indx / SAct
Aux Board 2, Motor 2 / Rotating Gobo Index / Sensor Always Active
BRD1 / NO / COMM
Aux Board 1 Communication Failure
BRD2 / NO / COMM
Aux Board 2 Communication Failure
LAMP / STRK / FAIL
Lamp Strike Failure
PAN / ENCR / FAIL
Pan Encoder Failure
PAN / NO / SENS
Pan Sensor Not Found
PAN / SENS / ACTV
Pan Sensor Always Active
SRCH/FOR/BRD1
Attempting to communicate with Board 1
SRCH/FOR/BRD2
Attempting to communicate with Board 2
TILT / ENCR / FAIL
Tilt Encoder Failure
TILT / NO / SENS
Tilt Sensor Not Found
TILT / SENS / ACTV
Tilt Sensor Always Active
WAIT
Retrieving Current Status
WRNG / SW / PROG
Wrong Software Program
www.carlosmendoza.com.mx