I
NSTALLATION
: I
NSTALLATION
P
ROCEDURES
2
0 2 . 9 6 7 3 . 0 0 0 1 D
02-M ay- 03
15
Installation Procedures
Installing Lamp
In the event the lamp was packed separately during shipment, it will be necessary to install in the
luminaire before use.
WARNING:
Ensure that power is removed from luminaire when installing lamp.
CAUTION:
Wear cotton gloves or other covering while installing lamp. Touching lamp glass with
bare fingers will leave oil and may cause the lamp to explode or reduce lamp life. If touched, use
alcohol and cotton cloth to thoroughly clean glass portion of lamp.
To install lamp:
Step
1. Ensure power is removed from luminaire.
Step
2. Remove lamp from shipping box.
Step
3. At backcap, using slotted screwdriver (or fingers) turn
captive knob until loose.
Step
4. Slide backcap away from head assembly (it will remain
attached by tether and lamp wires.).
Figure 2-1: Installing Lamp
Step
5. Install lamp by pressing into socket. Ensure lamp is fully seated in socket and parallel to
guide rods. (Lamp can be damaged when inserted through reflector if not parallel to guide
rods.)
Step
6. Align guide rods in guide holes and slide backcap into head assembly. Re-tighten captive
knob.
Note:
After installing a new lamp, it is necessary to adjust the beam for optimum performance. This
procedure is covered in
Captive Knob
Backcap Assembly
Guide Rod
Lamp
CAUTION:
Ensure lamp is seated
straight in socket before
re-installing backcap.
www.carlosmendoza.com.mx
