www.vareximaging.com
39
XRpad2 4343
U
SER
M
ANUAL
11.5.2
Cleaning the X-ray Detector
To clean the X-ray detector:
1
Turn off the X-ray detector and the power and communication tethered cable, if applicable.
2
Insert the XRpad2 Protective Insert into the battery compartment before cleaning or
disinfecting the detector.
3
Locate and read the cleaning instructions specified on the product label. Follow the product
instructions for cleaning.
4
Dispense wipe from container.
5
Visually inspect the device. If soil is present, use a wipe to remove soil from the device
surface. Use multiple wipes, as applicable, to remove all visible soil.
6
Take care to remove soil from seams, joints, and other difficult-to-reach areas.
7
Dispose of each wipe used for cleaning.
8
If visible residue from the cleaning product is evident after air drying, remove residue with a
general isopropyl alcohol wipe, and let air dry.
11.5.3
Disinfecting the X-ray Detector
To disinfect the X-ray detector:
1
Turn off the X-ray detector and the power and communication tethered cable, if applicable.
2
Insert the XRpad2 Protective Insert into the battery compartment before cleaning or
disinfecting the detector.
3
Locate and read the cleaning instructions specified on the product label. Follow the product
instructions for cleaning.
4
Wipe the entire surface of the target areas of the system until they are visibly wet with the
chemical solution. Target areas include any surface that was cleaned and/or any other
surfaces potentially contaminated during system use without visible soil.
5
Take care to wet seams, joints, and other difficult-to-reach areas.
Note
If you are using a disinfectant other than those specified, we recommend
you consult a specialist for the procedure for disinfection.
Note
If you are using a disinfectant other than those specified, we recommend
you consult a specialist for the procedure for disinfection.
Version
01
2017-11-03
