ENGLISH
4 - E
Installation
The lights are equipped with a rubber padded magnetic base for the installation on the
vehicle body or a suction cup: for the best performance we recommend to locate it on a
plain and clean surface, especially for the suction cup version.
Each light is provided with a tilt bracket allowing better directional control of the
optical set and a better visibility of the light signals.
WARNING: to remove the lights we suggest that you directly grasp the magnetic base
or the bracket.
Connections
In order to connect the two lights, a cable with an automotive grade, water tight
connector is provided.
To recharge the battery there is a classic plug connector.
Functionality
According to the label next to the switch, the set can work in two different modes
depending on your needs:
8.
RADIO Mode
: the set repeats the controls that are received from the
paired transmitter. The received functions are: TAIL LIGHTS,
DIRECTION INDICATORS and STOP. After 30 minutes of no
activity the receiver will enter a battery save mode and any command
transmitted will resume normal operation; after 4 hour of no activity
the receiver will enter a sleep mode with a negligible battery drain: it
will be necessary to turn OFF and then turn ON again to resume the
normal operation.
9.
ON mode
: only the tail lights are ON and the radio link is ignored, the
transmitter can remain connected to the towing vehicle.
Every set includes a paired transmitter, if you need to cancel the receiver’s memory or
pair a new transmitter, please consult the “Transmitter pairing” section in this guide.
WARNING: it is important to switch OFF the set (switch in the OFF position) when
not in use, this helps to preserve the battery life.
Summary of Contents for RXFM6
Page 15: ...ENGLISH 15 E NOTES ...
