Varec 2500, Installation And Operation Manual

Page: 27 / 124

Varec, Inc. 17
Table 7: Stilling Well Service Cone Roof Tank 6" Diameter Float — Installation Checklist
External Floating Roof Tank and Floatwell
Order Code T03, T13
Installation parts supplied include:
•
90° Elbow assembly (x2)
•
Gauge 'U' bolt kit
•
Support bracket assembly
•
Support bracket (x6)
•
gauge head and tape/cable
•
Float
•
Tape/cable connectors
Figure 11: External Floating Roof Tank and Floatwell
Installation Checklist
When installing a 2500 ATG system on a External Floating Roof Tank and Floatwell, complete
each installation step below. Check off a step when it is complete. Refer to Section
“Installation Schematics” on page 21 for overall dimensions.
8 Section “Reset the Counter” on page 40
9 Section “Calibrate the Counter” on page 41
10 Section “Initial Lubrication” on page 42
11 Section “Install a Transmitter and Replace all Covers” on page 42
12 Section “Initial Operation” on page 43
Step Description Complete
Step Description Complete
1 Section “Correct Float Positioning for an External Floating Pan Installation”
on page 25
2 Section “Installing Support Brackets & Pipework” on page 27
3 Section “Installing a Gauge Head at Grade Level” on page 28
4 Section “Float installation on an Out-of-Service Tank” on page 30
5 Section “Connecting the Cable to a Float in a Floatwell” on page 31
6 Section “Feeding the Tape to a Gauge Head Located at Grade Level” on
page 34
7 Section “Install Tape in the Gauge Head” on page 35
8 Section “Trimming the Cable at the Float in a Floatwell” on page 39
9 Section “Reset the Counter” on page 40