VLC5501 Vapormatic Immobiliser Installation Manual
13 of 21
Testing the system:
To complete the installation, these two system checks must be performed.
In order to test the system using the Keypad Override Disc, follow these instructions:
1.
Remove the battery from the Keypad Override Disc.
2.
Turn ON the ignition and wait for 10 seconds, the keypad red LED must stay
ON.
3.
If the Keypad green LED light illuminates, switch off the ignition for 4
minutes, and go back to step one.
4.
Try to start the engine. If the engine cannot be started, carry on with the next
steps. (If the engine can be started, installation has been carried out
incorrectly. Check electrical connections.)
5.
Assemble the Keypad Override Disc, you should see a small red LED light
flash on the PCB board. (Ensure the battery is installed correctly, positive on
the battery to positive on PCB board power strip)
6.
Turn the ignition ON
7.
Wait until you hear a double beep emitted from the keypad and the green LED
switches ON. (This can take up to 20 seconds)
8.
Try to start the engine. If the engine can be started, this test has been
successful.
**********Warning!!!!**********
In order to make both tests, wait for 4 minutes (approx) for system to passively arm
itself.
In order to test the system using the Keypad PIN code, do the following:
1.
Remove the battery from the Keypad Override Disc.
2.
Turn ON the ignition, the red LED must stay ON.
3.
If the engine cannot be started carry on with the next steps. (If the engine can
be started, installation has been carried out incorrectly. Check electrical
connections.)
4.
Turn ON the ignition, and enter factory PIN code ‘0000’ and press the
#
button to confirm. (See user’s manual, section
Entering factory PIN code
).
5.
Wait until you hear a double beep emitted from the keypad and the green LED
switches ON. (This should be within a couple of seconds)
6.
Try to start the engine. If the engine can be started, this test has been
successfully finished.
