INSTALLING THE RECON ROTOR SET:
1.
Inspect the propellers for loose screws and damage.
2.
Unfold the rotor arms so they are fully extended.
3.
Confirm all magnets on Vesper’s fuselage and rotor set are free of
sand and other debris.
4.
Orient the rotor set with the longer arms closest to the camera.
○
The longer bent arms should be on the front side of the
fuselage (near the gimbal), and the shorter unbent arms
should be on the rear end.
○
The polarity of the fuselage magnets will not allow the Recon
Rotor Set to attach if aligned improperly (see picture below).
5.
Attach the rotor set to the underside of Vesper’s Fuselage by snapping
magnets into place.
6.
Confirm installation: when spun lightly with a finger, all four propellers
should easily spin at least two full rotations.
62
Never attempt hand launching Vesper when using the Recon Rotor Set