25799 Jefferson Ave., Murrieta, CA 92562
1-800-VANIMAN (826-4626) USA
www.vaniman.com
CUT & CLEAN-I 03/20 Page 5
CUT & CLEAN CABINET
6. It is recommended that a dust collector is attached to the unit to remove excess media and improve
visibility during blasting.
SandVac
120V
PN: 10211
220V
PN: 10212
StoneVac II
120V
PN: 10201
220V
PN: 10209
Illustration A
MAINTENANCE
Vaniman products are designed to be low maintenance. However, as the materials used in a dust
cabinet are abrasive in nature, components do wear out. A few minor areas should be maintained
regularly for a long product life.
Glass Window:
Included with the unit is a free "Static-Cling" blasting shield for the inside of the window. These are
inexpensive protection for the viewing clarity of the window. Replace when necessary. Installation
instructions:
Method A
1. Make sure bottom side of blaster window is clean. If glass is significantly etched, replace with a new
window prior to installation of the Static Shield Protector.
2. Remove backing from Static Shield Protector.
3. Place one edge on blaster window and progressively lie shield on glass taking care to minimize bubbles
and wrinkles. The correct side of the shield is the side that the Vaniman logo is readable from the front
of the blaster.
4. Use a credit card or similar object to sweep bubbles out of protector.
5. When surface is significantly etched, replace with new shield protector.
Method B -- Recommended
1. Same steps as above except apply water or blue glass cleaner to window prior to installation.
2. Use credit card to sweep exess moisture out of window -- repeat until all bubbles and excess moisture
are removed. Any visible remaining moisture will dry in 24 hours and product can be used right away.
ENGLISH
