TENT PITCHING INSTRUCTIONS – F10 MTN 2 (UK)
INNER FIRST PITCHING
1.
Open out Inner tent, and position in desired location
2.
Assemble green pole structure with Axial Hub using the corresponding green webbing and eyelets
3.
Insert the poles' end tips into the eyelets on the rear corners of the inner/footprint
4.
Push other ends of poles into an arch, and insert tips into corresponding eyelets on corners of inner forming main dome of
pole structure
5.
Insert cross over poles end tips into the corresponding eyelets on the sides of the inner tent
6.
Push the other ends of the silver cross over poles into an arch, under the green main poles and insert pole tips into their
eyelets
7.
Suspend the inner tent from the pole structure using the clips. Start with the gated clips at the pole cross overs.
FLYSHEET
1.
Open out flysheet and position over the pole structure
2.
Attach the flysheet to the pole structure using Velcro tabs on the inside of the flysheet to hold the silver and green cross over
poles together
3.
Clip the corners of the flysheet into the corresponding clips at pole ends
4.
Place your tent in its final position and peg out all pegging points
5.
Tension the flysheet once pegged out. Finish by pegging out the porch(s)
6.
Peg out ALL guy lines using pin-pegs ensuring that guy line fabric attachment points are evenly tensioned
FLYSHEET FIRST PITCHING:
1.
Open out footprint and position in desired location
2.
Assemble green pole structure with Axial Hub using the corresponding green webbing and eyelets
3.
Insert the poles' end tips into the eyelets on the rear corners of the footprint
4.
Keeping tension on footprint, push other ends of poles up into an arch, and insert their tips into corresponding eyelets on
corners of footprint
5.
Insert the cross poles end tips into corresponding eyelets at sides of the footprint
6.
Push the other ends of the silver cross over poles into an arch, under the green main poles and insert pole tips into their
eyelets
7.
The Silver poles can stay in position if held by the green poles.
8.
Drag the flysheet over the pole structure, using the Velcro attachment points to hold the silver and green cross over poles
together.
9.
Clip the flysheet to the footprint using the side release clips
10.
Place your tent in its final position and peg out all pegging points
11.
Tension the flysheet once pegged out. Finish by pegging out the porch(s)
12.
It is then possible to attach inner tent to the pole structure using clips, and by putting pole end tips through both footprint
eyelets and inner tent eyelets