Operation
Danger
Danger
z
Power supply can only be connected after the wiring is completed and the cover is
installed. It is forbidden to remove the cover in live condition; otherwise, electric shock
may happen.
z
When auto failure reset function or restart function is enabled, isolation measures shall
be taken for the mechanical equipment, otherwise, personal injury may be caused.
z
When the driver is powered on, its terminals are still live even when it is in stop state. Do
not touch the driver terminals; otherwise electric shock may happen.
z
The failure and alarm signal can only be reset after the running command has been cut
off. Otherwise, personal injury may be caused.
Note
Note
z
Do not start or shut down the driver by switching on or off the power supply, otherwise,
the driver may be damaged.
z
Before operation, please confirm if the motor and equipment are in the normal use
range, otherwise, the equipment may be damaged.
z
The heatsink and the braking resistor have high temperature. Please do not touch such
device; otherwise, you may be burnt.
z
When using in some special machine, please use a mechanical interlock device.
z
The phase rotation of output U/T1, V/T2 and W/T3 should be identical with that of the U,
V and W of the motor, otherwise fault will occur.
z
Please do not change the driver parameter randomly. Most of the factory settings of the
driver can meet the operating requirement, and the user only needs to set some
necessary parameters. Any random change of the parameter may cause the damage of
the mechanical equipment.
Maintenance,
Inspection
Danger
Danger
z
In the power-on state, please do not touch the driver terminals; otherwise, electric shock
may happen.
z
If cover is to be removed, the power supply must be disconnected first.
z
Wait for at least 10 minutes after power off or confirm that the CHARGE LED is off
before maintenance and inspection to prevent the human injury caused by the residual
voltage of the electrolytic capacitor in main circuit.
z
The components shall be maintained, inspected or replaced by qualified electricians.
Summary of Contents for TS-I Series
Page 1: ...User Manual TS I series servo drive is introdution V T ...
Page 2: ......
