TS
−
I Special servo drive for hybrid electro-hydraulic system of injection molding machine User Manual
Chapter 3 Digital actuator button, display and motor learning
35
For example, setting P0.01=3: Restore all the parameters in P area to factory settings except the motor
parameters (F9 group).
3.8.2 Setting Frequency
For example, setting P0.05=25.00Hz.
3.8.3 Setting Password
For example, set user password P0.00 0003.
3.8.4 Password Verification
Assume that the function codes after P0.00 are protected by password and the password is 3. If the
password protection is not enabled, you can press ESC+PRG+
∧
to enable the password in last example
of P0.00. You can verify the password according to the following process:
Note: If you use RS 485 communication mode to perform password verification, please refer to Appendix A.
Description of register 0xF000 in Modbus communication protocol.
25.00
P0.0 0
0.0.0 .0.
3Times
25.00
∧
PRG
PRG
ESC
PRG
P0.0 1
0.0.0 .3.
3.8.5 Clearing Password
For example, clear the user password P0.00.
3.9 Running for the First Time
The following is the first on the routine operation of electric operation, such as failure, please control
fault and alarm signal list judge causes, troubleshooting.
Summary of Contents for TS-I Series
Page 1: ...User Manual TS I series servo drive is introdution V T ...
Page 2: ......
