SECTION 4: INSTALLATION
AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 36
090019-OP_r0
1. Drill four (4) 9/16” mounting holes in the
service body floor on a 12.75” by 34.88”
square pattern at the desired mounting
location. Ensure that all proper machine
clearances will be maintained.
2. For units without a fuel tank, follow these
steps:
• Mount the electric fuel pump at the
desired location on the service body
keeping it as close to the truck fuel tank
as possible. Mount the electric fuel pump
a maximum distance of 24 inches from
the bottom of the tank (
Figure 4-1
).
• Install 1/4” fuel line from the vehicle tank
to the 1/4” fuel filter under the hood of the
machine.
• Ensure that the lines do not make contact
with sharp edges, moving parts or
exhaust heat (consult
Appendix A,
Section A.6, Hose Installation Guide
for
assistance in running hose lines).
• Units must have a 70 micron fuel filter in
line before the pump.
3. Install the remote control panel (Optional) at
the desired location on the service body and
route the control trunk line to the location
where the unit will mount. Ensure that all
sharp edges that the trunk-line contacts are
shielded or grommeted, and that there are
no excessively sharp bends in the trunk-line.
Ensure the trunk line does not come in
contact with exhaust parts.
4.4 MACHINE PACKAGE MOUNTING
When determining package position on vehicle, be aware
of the minimum space requirements needed for cooling
and circulation, and also package access for performing
maintenance (see
Section 4.5, Installation and
Dimensions Diagram, Part 1 and Part 2
). To prepare
the machine for mounting, refer to
Figure 4-3
and the
following procedure:
1. To unbolt the unit from the skid, remove the
mounting nuts [
A
], lock washers [
B
],
washers [
C
] and mounting bolts [
D
] securing
the machine to the shipping crate.
NOTE
For set up without a fuel tank, where an
additional fuel pump is required, order the
following kit:
•Kit no. MA57870
WARNING
Installation must adhere to the safety
precautions listed in the Safety Section
of this manual for cooling and noxious
fume ventilation.
If mounting footprint is tighter than the
recommended minimum requirements,
consult the Vanair Service Department
for application installation
recommendations.
KEY
DESCRIPTION
A
FUEL PUMP
B
FUEL FILTER
C
FUEL TANK
D
24” CLEARANCE TO BOTTOM
OF FUEL TANK
Figure 4-1: Fuel Pump Clearance
A
B
C
D
NOTE
Mounting brackets are available to space
panel off from truck body (
Figure 4-2
).
Contact Vanair
®
.
