AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
SECTION 2: DESCRIPTION
090019-OP_r0
Page - 27
maintenance since they do not have slip rings, nor
slipping contacts. The end brackets are die-cast in a high
resistance aluminum alloy, the shaft is C45 steel, and is
fitted with a keyed fan. A 20 and 25 amp, in-series circuit
breaker protection is also included.
2.5 INSTRUMENTATION
This section describes the basic functions of the controls
located on the instrument panel. To insure that the
controls are engaged correctly, Consult the various
operating procedures as described in
Section 5,
Operation
, and
Appendix B
.
See
Figure 2-8
. The standard instrument panel for the
Air N Arc 200 Series contains a volts/amps display,
welder function switches (welder CC/CV toggle switch,
and DC charger/welder toggle switch), welder DC charge
WARNING
DO NOT rely on breakers for overload
protection.
These breakers are temperature and time
dependant, and cannot be relied upon for
overload protection.
System Component or
Component Group
Manual
Section
Location
INSTRUMENTATION
2.5
page 27
Volts/Amps Display
2.5.1
page 29
Welder Function Switches
2.5.2
page 29
Fuel Gauge/Hour Meter
2.5.3
page 29
Engine Control (ON/OFF/START)
Switch
2.5.4
page 29
Circuit Breaker Overload Trip/Reset
Buttons
2.5.5
page 29
AC Voltage Outlets
2.5.6
page 30
Generator Control ON/OFF Toggle
Switch
2.5.7
page 30
DC Charger Mode Toggle Switch
2.5.8
page 30
Volts/Amps Manual Adjustment Dial
2.5.9
page 30
Compressor Air Pressure Switch/
Gauge
2.5.10
page 30
Battery Cable Receptacle
2.5.11
page 30
Weld Lead Connection
2.5.12
page 30
KEY
DESCRIPTION
A
LIFTING BAIL (reference)
B
DC GENERATOR
C
AC GENERATOR
Figure 2-7: Generator Assembly
B
A
C
