(Fig. 1)
2
&
Outside Zone
All installations must comply with guidelines which are based on a zonal
concept. The diagram above illustrates this concept and must be followed to
ensure the safe installation of electrical appliances in the bathroom. These
regulations apply to domestic installations only. Installations must be made
in accordance with the current IEE wiring regulations and relevant building
regulations. We recommend that all electrical bathroom products should only
be fitted by a suitably qualified, Part P registered electrician.
Thank you for purchasing this product.
Please read through these instructions carefully and refer back to them
during installation to ensure that your product is fitted safely and that it
retains its high quality finish.
Please retain this leaflet for future reference.
Before installation, ensure the domestic electrical mains supply to which
the mirror is to be connected is turned off. Before drilling, ensure that
there are no hidden cables or pipes in the wall.
Mounting Points Diagram (Fig. A)
Illuminated Mirrors
Dritto 60
Art No. 221110
/ Dritto 80
Art No. 221111
Dritto 100
Art No. 221112
Installation
1. Position the mirror in a suitable location (according to the
zonal diagram - Fig. 1), ensuring that the domestic electrical
mains supply is within reach of the electrical entry point of the
product.
2. Carefully mark the position of the mirror using a soft pencil
ensuring it is level. Remove the mirror and mark the mounting
points. Please ensure that all marked mounting points
accurately match up with the fixing points on the mirror.
3. Using a suitable drill bit, drill holes in the marked positions to a
suitable depth. If drilling through tile, use a ceramic drill bit.
4. Insert wall plugs level with the surface of the wall. If fitting
to a tiled surface, wall plugs should be inserted below the
tile surface to avoid cracking. NB. For plasterboard walls,
specialist fixings should be purchased, available from any DIY
or hardware store.
5. Screw supplied fixings into wall plugs.
6. Ensure the domestic electrical mains supply to which the
mirror is being connected is turned off. Connect the domestic
mains supply to the terminal box according to the wiring
diagram (Fig. B).
7. Hang the mirror in position.
8. Switch the domestic electrical mains supply for the mirror back
on.
mounting points
REAR VIEW
Operation Instructions
To turn illumination on or off, press the touch sensor.
To cycle through warm to cool colour temperature, press and hold the
touch sensor - release when the desired colour temperature has been
reached.
Heated Pad is only on when mirror is illuminated.
Care Instructions
Do not use abrasives or solvents when cleaning this product. Wipe off all
water spillages as soon as possible using a soft, damp cloth.
Aftercare Service
In the unlikely event that this product should fail please contact our
customer services.
WEEE compliance
Must not be mixed with general household waste
live
earth
neutral
MAINS SUPPLY
LUMINAIRE
Live supply can be R ed or Brown
Neutral supply can be Blue or Black
Earth supply is Green and
Yell ow
Live is Brown
Neutral is Blue
Wiring Diagram (Fig. B)
Caution
We recommend that you place this mirror on a soft flat surface to ensure no breakages.
We also recommend that you leave corner protectors on until final fitting.
This product is suitable for installation in zones:
EN
