[page 12] | gpelectric.com
PLANNING LOCATIONS
MC4 Connector
Legend
Fuse
Battery Bank
Refrigerator
Vent Cover
or Cable Entry Plate
Fuse
Inverter
Inverter
Remote
AC
Loads
AC
Panel
Transfer
Switch
Fuse
Converter /
Charger
Shore Power
/ Generator
PWM 30
Solar Charge
Controller
MC4 Red Postive
Extension Cable (25 ft)
"CLICK"
MC4 Black Negative
Extension Cable (25 ft)
Items Supplied in
Weekender, Elite, Extreme
Kits Only
Solar Panel
3.3 LOCATING THE GP-PWM-10 OR GP-PWM-30 SOLAR CHARGE CONTROLLER
The GP-PWM-10 or GP-PWM-30 is included in all Go Power! RV Solar Kits detailed in this manual except for the expansion
kits (50E and 100E). The GP-PWM provides the necessary protection for the RV battery system. A condensed version of the
installation instructions appear in this manual. However, please read the full installation manual included with the GP-PWM-10
or GP-PWM-30 Solar Charge Controller.
1. Plan where the Solar Charge controller will mount, see Figure 3-B.
• The Solar Charge Controller is designed to be mounted vertically in an indoor location inside a weatherproof
enclosure.
• Ideally the Solar Charge Controller should be located so it can be easily seen for monitoring system operation.
• The location will need access to the cable ends from the solar panels and the battery compartment.
WARNING: Failure to secure the Solar Charge Controller could cause it to become dislodged while the RV is
in transit and cause severe damage to the unit and/or the RV.
Note
FIGURE 3-B