1
July 2018
Remote Control Initial Set-up
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the fi rst use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver’s
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the sychronization
is set. If you hear one long beep, this indicates the
code learning sequence has failed or the wiring is
incorrect.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
OPERATION MANUAL
GV60 MAX
with or without optional fan
GV60 MAX Electronic Ignition Remote Control
used on Valor heaters of Series G3.5, G4, H5 and H6
For Valor heaters 700, 780, 785, 1100, 1150 and 1400 installed with or without a
fan (blower)