Page 1 of 5
#796 CIRCULATING FAN KIT
DECEMBER 1999
INSTALLATION and OPERATING INSTRUCTIONS
Canadian and American Gas Association approved for use only with
VALOR LEGEND ULTRA MODEL 737X
1. DESCRIPTION OF SYSTEM
The Valor Legend Ultra Model 737 has been designed to accommodate the
installation of an air circulation fan. Operated by a hi/ lo/ off fan control and
a thermally actuated switch, it is designed to boost the natural convection
process through the heater, this may be a desirable feature dependent on the
fireplace location and room layout. The circulating fan may be installed
before the heater installation or as a retrofit at a later date.
2. ELECTRICAL REQUIREMENTS.
The fan kit requires a power supply of
120 Volts, 1 phase, 60 Hz. Full
load current is less than 1 amp
.
This power supply must be installed and grounded in accordance with local
codes, or in the absence of local codes, with the current Canadian
Electrical Code CSA C22.1. or in the USA the National Electrical Code
ANSI/NFPA70 latest edition.
3. FAN KIT COMPONENTS
The complete #796CFK Kit contains the following:
•
Fan /Motor c/w mounting plate,
wiring harness c/w thermal switch
and Molex connector.
•
Hi/ Lo/ Off controller/ junction box
c/w Molex receptacle and 6’ cord
set.
•
Right hand heat baffle
•
Left hand heat baffle
•
Control mounting bracket
•
Screw and cable tie package
f i r e - p a r t s . c o m
