4001309/01
31-3/4”
35-3/4”
The 1240BPK Backing Plate Kit can be installed on
the 1200 engine once the wall finish is completed.
NOTE: To install this backing plate, the
surface
of the finished hearth or floor must be at the
same level as the bottom of the heater. Please be aware that the backing plate mounting
can
ONLY accommodate 1/2” wall thickness.
Note:
This kit must be installed or serviced by a qualified installer, service agency or gas supplier.
These instructions are to be used in conjunction with the main installation instructions for the 1200.
Installation
Remove the 6 screws retaining the thin black metal strips to the top and sides of the fireplace opening as shown.
Remove the strips and discard them as they are not needed for this installation.
Slide the backing plate on the fireplace and fix it with 2 screws at the top and 2 screws at the bottom on each
side as shown.
1.
2.
Overview
1
2
1240BPK Backing Plate Kit
INSTALLATION INSTRUCTIONS
1200 Heater
1240BPK Backing Plate
Wall Finish
To be used
only
with
Valor Model 1200 Heater
