Valley VRI-iS, Installation Manual, Page: 18 / 102

18
Installation Instructions
Temporarily Install GPS Position Tower Box
Temporarily install the GPS position tower box at the pivot point to set the pivot point GPS position.
!
DANGER
• THE CONTROL PANEL AND COLLECTOR RING CONTAIN HIGH VOLTAGE! 480 VOLTS CAN KILL. AL-
WAYS DISCONNECT ELECTRICAL POWER BEFORE SERVICING OR PERFORMING MAINTENANCE
TO THE MACHINE.
!
CAUTION
• ALWAYS IDENTIFY POTENTIAL FALL HAZARDS AND DETERMINE IF FALL PROTECTION EQUIP-
MENT IS APPROPRIATE FOR THE TASK, BEFORE BEGINNING THE WORK.
1. Verify that all dip switches are set to Open, ex-
cept switch number 6, which should be set to Off.
See Figure 18-1.
2. Use a clamp to secure the tower box in position
near the collector ring. See Figure 18-2.
3. Use a cable adapter pn 03E4488 (included with
VRI-iS panel kit) to connect the collector ring
VRI-iS cable to the inner valve cable on the GPS
position tower box. See Figure 18-2.
Turn Power On
4. Turn the power service disconnect and control
panel main disconnect switch On.
5. Continue with Setup Control Panel for GPS Posi-
tion on the next page.
1
2
Off
Figure 18-1 1. GPS Position Tower Box
2. Dip Switches
3
2
1
5
4
6
Figure 18-2 1. Clamp
2. Tower Box
3. Collector Ring
4. Cable Adapter
5. VRI-iS Cable
6. Inner Valve Cable
NOTE
• Special attention should be taken when
plugging in any connectors. Connectors
are keyed and orientation is labeled with
an arrow, however with enough force the
connectors can be inserted incorrectly.