Valley VRI-iS, Installation Manual, Page: 16 / 102

16
Installation Instructions
Install Cord Connector(s)
15. Install cord connectors and route wiring based
on whether there is a running light or not.
• Without Running Light - see Figure 16-1.
(a) Install a 1/2 inch cord connector in collector
ring housing.
(b) Route 50 ft VRI-iS cable through cord con-
nector and up to four position terminal strip.
• With Running Light - see Figure 16-2.
(a) Attach one 1/2 inch tee conduit to the col-
lector ring housing with one 1/2 in x 1-1/8 in
nipple and two romax nuts.
(b) Remove plate from side of conduit and install
the 1/2 in strain relief in one end of conduit
and the 1/2 in cord connector in the other
end.
(c) Route running light cable through the 1/2 in
strain relief on one end of conduit and into
collector ring.
(d) Route VRI-iS cable through the 1/2 in cord
connector on the other end of conduit and
into collector ring.
2
1
3
Figure 16-1 Aeromotive Collector Ring Shown
1. 1/2 Cord Connector
2. Housing 3. VRI-iS Cable
5
8
1
4
7
3
6
9
2
9
8
Figure 16-2 Aeromotive Collector Ring Shown
1. 1/2 Tee Conduit
2. Housing
3. 1/2 x 1-1/8 Nipple
4. Romax Nut
5. Conduit Plate 6. 1/2 Strain Relief
7. 1/2 Cord Connector
8. Running Light Cable
9. VRI-iS Cable