OMNIA
36
The light tower is equipped with a telescopic arm that allows it to be
lengthened:
To change the height of the turret, loosen the ring nut while holding the
upper part of the turret.
Pull the upper part up to the desired height, then re-lock by tightening the
ring nut.
6.7
PREPARING FOR USE
This paragraph is intended to list the important task to use the machine:
•
Power the machine on by turning the selector on the electrical panel of the machine clockwise - Figure 5-23.
•
Insert the power by pressing the Machine Power key (A), Figure 6-2.
Note:
If the button does not light up, check if any of the emergency buttons - Figure 6-1 - were pressed down, if so
disarm them (see par. 6.1) and repeat the pressure of the Machine Power key.
•
Turn on the PC on and start the V-Studio program
WARNING! To enable the connection between the PC and the machine, the machine must be switched on
and connected to the PC before opening
V-Studio
•
From V-Studio control panel click on SmartCut, once the connection has been established, make the machine
ready using the ROXY button.
•
Lower the loading feeder and place the materials as described in paragraph 6.7.
•
Start the suction pump using the selector (1) and according to the size of the media open or close suction zone (3)
simply turning taps CW or CCW as images explain (2) Figure 6 2.
•
On pc Open ImageCut and add the file to be executed and the quantities required, Start the automatic cycle and
follow the instructions provided on the screen.
•
Make the necessary adjustments Paragr. 7.
•
To interrupt a process, pause and restart it, simply press the appropriate keys on the PC (see software manual).
•
In case of danger, it will be sufficient to press the emergency button to instantly block and cut power off to the
machine. Figure 6-1.
To reset the machine:
•
Disarm the emergency button (see paragraph 6.1)
•
Press the Machine Power button (A), Figure 6 2
•
Restore the program on the PC (see software manual).
Figure 6-7
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...
