OMNIA
9
2.4
OPERATOR SAFETY MEASURES
According to the type of work conducted with the machine some maintenance work will require the operator to wear
gloves and safety glasses.
While servicing the machine, it is recommended to use personal protective equipment:
•
Gloves while cleaning the machine;
•
Gloves with any operation involving the tools, cutting blades.
•
Safety glasses while performing maintenance and inspection of the compressed air system.
2.5
OTHER RISKS
This section has the scope of identifying the other risks associated with using the machine so that operators can identify
situations in which they should take particular care when doing specific tasks.
•
During installation take the outmost care when positioning the machine on its base, where there could be a risk of
you losing your balance and dropping the work table. Only people directly involved in the assembly operation
should be allowed into the assembly area.
•
Be very careful; to avoid possible injury due to the incorrect handling of the blades and the cutters while
performing any tasks on the tool or on the blade itself, always wear safety gloves.
•
To avoid possible injury to hands or fingers do not to place your hands on the worktable, under the cutting head
carriage or the cutting head while the machine is working.
•
Wait for at least a minute after switching the machine off before opening the electrical box for maintenance so
that any residual electrical energy has had time to dissipate.
•
Even if the machine is stopped the "EMERGENCY" button must be pressed to put the machine into “suspend mode”
before doing any maintenance work (including adjustments).
NOTE!
Before doing any maintenance to the electrical system the operator must read this manual
and refer to the circuit diagrams provided.
NOTE! This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
2.6
REQUIREMENTS FOR THE CORRECT INSTALLATION OF THE MACHINE
•
Attention: It is mandatory that the electrical system to which the machine is connected be equipped with a
differential switch.
•
Attention: It is mandatory that the pneumatic system to which the machine is connected be equipped with a
tap to shut off the air and drain the pneumatic circuit of the machine.
•
Make sure that there are at least 60 cm of free space around the machinery to facilitate maintenance (also
consider the footprint for opening electrical panels, etc.) see paragraph "external dimensions" and paragraph
"installation and operator area".
•
Make
sure that you have an electrical and pneumatic system suitable for the machine’s absorption (see
technical data sheet).
Summary of Contents for OMNIA
Page 1: ...OMNIA Instruction and Maintenance Manual...
Page 2: ......
Page 65: ......
Page 66: ...002695 rev 02...