Page 15
Owner’s Manual - SRF40
ENGLISH
4.1 Noise coming from the fireplace
It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction noise during
the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.
It is also normal for the fan to make some noise when it comes on. This noise can be reduced somewhat
by turning down the speed of the fan with the variable speed control. Be aware, however,that this will
reduce the volume of heated air circulated into the room by the fan.
4.2 First operation
Burn your fireplace for at least six hours the first time you use it. Place the blower in the OFF
position during this time.
It is normal for your gas fireplace to give off some odor the first time it is burned. This is due to the curing
of the paint and oil from the manufacturing process. Please ensure that your room is well ventilated -
open a window.
4.3 Controls
There are two ways to control your fireplace
1- With a wall Switch
as shown in the following picture, the firepace can be turned On (Hi only and OFF
with the wall switch. (See installation instruction for its installation) The fireplace flame ON/OFF is the
only function that will operate; no flame adjustment, light or blower will work when using the wall switch.
The wall control switch should be turned OFF when the fireplace is not being used for extended periods of
time.
ON
OFF
REMOTE
PRG
Turned on
Turned off
Program
(Pairing)
For use of the
multifonction
remote
