Issue
6
1
947075
V-1095
70V PAGING EXPANDER
INTRODUCTION
Paging Amplifier
Output
COM
100V
COM
25V
70V
100V
Output
Valcom One-Way
Speaker/Amplifier
Assemblies
24VDC Regulated
Power Supply
or "A" Battery
1
150
V-1095 70V
Paging Expander
* The V-1095 does not require a power supply.
The power supply is required for speaker/amplifier assemblies.
*
25V
70V
output)
single 25, 70 or 100V
(V-1095 connects to a
OR
OR
These instructions contain the specifications and
information necessary to install, operate and maintain the
V-1095 70V Paging Expander.
SPECIFICATIONS
Design
The Valcom V-1095 70V Paging Expander is used to
expand 8 Ohm, 25V, 70V or 100V systems into amplified
speaker assemblies. The unit comes with its own surface
mount box which provides 1/2" conduit access. The unit
will accept input signal from a 8 Ohm, 25V, 70V or 100V
paging system and reduce it to a low impedance reduced
level output.
Applications
•
To expand existing 8 Ohm/25/70/100V paging
systems without replacing the main amplifier. A
V-1094A preamp expander may also be required
depending on the number of speakers added.
•
To provide master volume control convenience to all
or a portion of a paging zone.
Dimensions/Weight
•
4.44"H x 2.75"W x 2.88"D
(11.28cm H x 6.99cm W x 7.32cm D)
•
0.9 lbs. (0.41 kg)
Nominal Specifications
Input Impedance:
Paging Amplifier
Output
COM
8 Ohm
COM
25V
70V
100V
Output
Valcom One-Way
Speaker/Amplifier
Assemblies
24VDC Regulated
Power Supply
or "A" Battery
1
150
V-1095 70V
Paging Expander
* The V-1095 does not require a power supply.
The power supply is required for speaker/amplifier assemblies.
*
100V
20 K Ohm
70V
10 K Ohm
25V
1.25 K Ohm
Output Impedance:
8 Ohms
Frequency Response:
50Hz to 20KHz +3dB
INSTALLATION
These instructions cover only the installation of the
Valcom V-1095. Consult the practices of other
equipment if other equipment is being used.
Audio and Power Connections
Expanding a 25/70/100V Amplifier
Figure 1
Expanding an 8 Ohm Amplifier Output
Figure 2
