MUS0330202
03/10/2014
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 [email protected] www.valcomelton.com
75
5.9 FILLING THE TANK
Before filling the tank, put on goggles, gloves and long sleeves to
avoid possible burns from splashes of hot adhesive.
Models type A / B (Without Vacuum Feeding):
1.
Ensure that the tank is clean and free of foreign particles.
1.
Fill the heated tank with the hot-melt material, to a maximum of
10mm below the edge of the tank.
2.
Close the tank cover immediately after filling the tank.
Models type C (With Vacuum Feeding):
1. Make sure that the tank is clean and free of foreign
particles.
2. In this case, the equipment is fed automatically by the
installed vacuum feeder. The sensors detect when the tank
needs adhesive, as well as when it is no longer needed.
This way, the person handling the equipment does not have
to worry about anything except making sure the vacuum
feeder is always supplied with adhesive, in the container
used to hold it. Said container must be placed near the
equipment so the tubes comprising the vacuum feeder are
not pulled, which might cause damage.
Filling tank
