MUS0330202
03/10/2014
VALCO MELTON S.L.U. Pol. Ind. Agustinos C/G 34 3116 0 ORCOYEN, NAVARRA
TEL: +34 948 321580 Fax: +34 948 326584 [email protected] www.valcomelton.com
70
Warning: It is recommended that the Machine Adjustment
Section
is
read, understood, and followed before attempting to read this
Section and operate the Universal Temperature Control unit.
OTHERWISE, DAMAGE TO EQUIPMENT AND PERSONAL INJURY
COULD OCCUR.
5.1 START THE UNIT
To start the unit, do the following:
1.
Toggle the Power On/Off Switch to the “On” position to power up the
system.
Note: The Standby LED will illuminate green when the power to the
unit is on. If the Standby LED illuminates orange, the unit is in
Standby Mode. Press the Standby Button to turn the unit on.
Once the unit has completed its start-up sequence, it will turn on the
heaters in the tank and all active hoses and guns. The heater’s
corresponding Zone LED will illuminate green when the heater is on.
Standby Key
Power On/Off Switch
Tank Heater LED
System Ready LED
Warning/Alarm LED
Setback On/Off Key & LED
Setback On/Off Key & LED
Standby Key & LED
Hose Zone LEDs
Gun Zone LEDs
Heater (temperature) Menu Key & LED
Setup Key & LED
Valve Menu Key
Navigation Keys
