2020-02
USER MANUAL
SAFETY CABINET
BM 1993
Before you start
The lock can handle two opening codes: Master code and User code 2. The Master code is set from the factory
to 123456. User code 2 is submissive to the Master code and is not included in the Factory settings. The Master
code must be changed before you can program User code 2.
The lock signals with a beep and a flash with every correct action, and it signals with a long beep and red flash
with every wrong action.
Always program the lock with an open door and check the result before you close the door.
Open the lock
1.
Push ”ON”. The lock s
ignals with a beep and the green light comes on.
2.
Enter Master code (Factory Master code. 123456) or User code 2. The lock signals with a LED flash.
3.
Turn the handle clockwise within 4 seconds.
Open the safe
1.
Close the door completely. Make sure nothing gets jammed.
2.
Turn the handle anticlockwise.
Change Master code
1.
Open the lock.
2.
Push ”ON” and then ”ENTER”.
3.
Push 1 and then “ENTER”.
4.
Enter the current Master code and then “ENTER”.
The lock signals with 2 beeps and LED flashes.
5.
Enter a new 6-8-digit
code and then “ENTER”.
The lock signals with 2 beeps and LED flashes.
6.
Enter the new 6-8-digit
code again and then “ENTER”.
The lock signals with 2 beeps and LED flashes.
Activate User Code 2
1.
Open the lock.
2.
Push ”ON” and then ”ENTER”.
3.
Push 2 and then “ENTER”.
4.
Enter the current Master code and then “ENTER”. The lock signals with 2 beeps and LED flashes.
5.
Enter a new 6-8-digit User
code and then “ENTER”. The lock signals with 2 beeps and
LED flashes.
6.
Enter the new 6-8-digit User
code again and then “ENTER”. The lock signals with 2 beeps and LED flashes.
Change User code 2 without Master code
1.
Open the lock.
2.
Push ”ON” and then ”ENTER”.
3.
Push 3
and then “ENTER”.
4.
Enter the current Master
code and then “ENTER”. The lock signals with 2 beeps and LED flashes.
5.
Enter a new 6-8-
digit User code and then “ENTER”. The lock signals with 2 beeps and LED flashes.
6.
Enter the new 6-8-
digit User code again and then “ENTER”. The lock signals with 2 beeps a
nd LED flashes
Delete User code 2
1.
Open the lock.
2.
Push ”ON” and then ”ENTER”.
3.
Push 0
and then “ENTER”.
4.
Enter the current Master code and then “ENTER”. The lock signals with 2 beeps and LED flashes.
See other side, how to change battery
