Vaisala MGP261, User Manual

Page: 43 / 90

1. Connect to Insight (see Connecting to Insight Software (page 35) ).
2. Select > Configure Device , and then one of the 3 analog outputs.
3. Select the measurement parameter that is sent on the output channel you are configuring,
set the scaling for the output, and define the output level that indicates an error.
4. Store the selections with Save and exit with Close .
5. Repeat the configuration for each output (analog outputs 1, 2, and 3) as required.
More Information
‣
Wet Basis and Dry Basis Measurement Parameters (page 42)
6.4 Changing Units in Insight
Figure 19 Unit Selection in Insight
You can change the units of parameters (for example, metric or non-metric temperature) in
the Unit Settings menu in Insight.
1. Connect to Insight (see Connecting to Insight Software (page 35) ).
Chapter 6 – Analog Output Configuration
41