Vaisala HUMICAP HMP155, User Manual, Page: 45 / 102

Example
>intv 1 min
Interval : 1 min
>
4.4.4 SEND command
Use the SEND ADDR command, where ADDR is the address of the probe, to view the reading
once in the STOP mode.
You can use
SEND
without the address in the STOP mode. The output format
depends on the parameters the probe can print.
The following example shows SEND without a parameter.
>send
RH= 24.9 %RH T= 22.1 'C
>
4.4.5 SMODE command
Use the
SMODE
command to set the user port to permanent STOP, RUN, POLL, or SEND mode.
SMODE [xxxx]
The output mode you select is activated after power outages.
Parameter Description
xxxx
STOP, RUN, POLL, or SEND
Table 21 Output modes
Mode Output Available commands
STOP Only with the SEND command All (default mode)
RUN Automatic output
S
POLL Only with the
SEND
[
addr
] command
??
SEND
[
addr
]
OPEN [ addr ]
Chapter 4 – Operation
43