Chapter 4 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 45
ASEL
[
xx
] [
low high
]<cr>
where
xx
= Analog channel output quantity
low = Low limit of scaling
high = High limit of scaling
Examples:
>asel
Quantity : RH
Level Lo : 0
Level Hi : 100
>
>asel td
Quantity : TD
Level Lo : -40
Level Hi : 60
>
>asel td -10 60
Quantity : TD
Level Lo : -10
Level Hi : 60
>
Test the Analog Output
Use the
ATEST
command to test the analog output. The
ATEST
command will force the output to the given value, which can then be
measured with a calibrated multimeter. The command uses the currently
selected analog output mode (voltage or current) so you do not have to
specify the unit.
Before testing, check the currently set analog output mode using the
AMODE
command. After testing the output, give the
ATEST
command
again to exit the test mode.
ATEST
[
xxx
]<cr>
where
xxx
=
Analog channel output value (V or mA)
Example:
>atest 2.5
2.500000, 587f
>
>atest
>
