Vaisala Drycap DMT152, User Manual

Page: 53 / 72

5.8.3 Display Command List
Use the HELP command to display the available commands.
help <cr>
5.8.4 Set Time
Use the
TIME
command to view and set the transmitter clock. The clock does not have a
battery backup – it is reset to 00:00:00 when the transmitter is powered up or reset.
Table 35 TIME command
Syntax Description
TIME
Display the current time.
TIME [hh mm ss] <cr> hh Hours (24-hour clock)
mm Minutes
ss Seconds
Examples:
time 12 30 00
12:30:00
time
12:30:00
5.8.5 Reset Transmitter
When the RESET command is given, the transmitter will restart as if it had just been powered
on. All transmitter settings are retained. The serial line mode of the transmitter will be set to
the mode that was set using the
SMODE
command.
As the transmitter starts up, it performs the startup sensor purge and auto-calibration before
resuming measurement.
RESET
<cr>
5.8.6 Set LED Voltage
With the LED command, you can set the supply voltage that is provided to the LED when the
LED alarm mode is used. If you are using the Vaisala LED cable, leave this setting at the default
voltage (2.80 V).
Chapter 5 – Serial Line Operation
51