Chapter 5 ________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 47
Closing the Connection to a
Transmitter in POLL Mode
The
CLOSE
command closes the connection to a transmitter.
CLOSE
<cr>
Example:
close
line closed
Show Transmitter Uptime
Use the
TIME
command to show how long the transmitter has been
operating since it was last reset or powered up.
TIME
<cr>
Example:
time
Time : 00:51:41
Reset Transmitter
Use the
RESET
command to reset the transmitter.
RESET
<cr>
When the
RESET
command is given, the transmitter will restart as if
it had just been powered on. All transmitter settings are retained. The
serial line mode of the transmitter will be set to the mode that was set
using the
SMODE
command.
Restore Factory Settings
Use the
FRESTORE
command to restore the factory settings to the
transmitter. All user settings will be lost.
FRESTORE
<cr>
