COMMISSIONING
59
5.3.7
End segment with end cap (sliding)
Assembly instructions
Requirements:
Clean and tidy workplace.
Required tools:
⚒
Screw driver PH1
Assembly steps:
1. Mount the connectors and connecting cap on the last section.
2. Clip the end segment into the hanger and connect the section.
3. Insert the screw terminals in both conductor rail ends and push the transfer guide
over the terminals. Mount the screws with 3 Nm.
NOTICE!
►
Screw torque: Observe 3 Nm!
4. Remove the assembly safety device on the infeed side which was mounted in
Chapter: „5.3.3 “.
Summary of Contents for VCL Series
Page 95: ...INDEX 93 U Unloading 88...
Page 96: ...CE Technical Documentation...
