CRX 425-625
01.05.2015 1
19
2.4
Selecting hitching points
Figure 2.5
The implement is designed for category III three-point hitching.
2.4.1
Hitching point for top link
In order to minimise the lifting force required, the top link should be fitted to a high hitching point
on the tractor and a low hitching point on the implement.
The round holes (A) are to be used if the length of the top rod will be used to adjust the parallel
alignment of the implement. When using these hitching points, the tractor's hydraulic arms should
be in the floating position when driving in the field.
The elongated hole (B) is to be used if you want to adjust the parallel alignment of the implement
using the height adjustment setting of the hydraulic arms. Adjust the length of the top link until
the pin is in the centre of the elongated hole when the tool is parallel to the ground. Then make
fine adjustments using the hydraulic arm height setting whilst driving the implement in the field.
A
A
B
