Camera Behavior Settings – RoboSHOT 12 HD-SDI and RoboSHOT 30 HD-
SDI
Older RoboSHOT cameras use DIP switches to set camera behaviors; the RoboSHOT Elite series
cameras set all camera behaviors in the web interface.
A label on the bottom of the camera provides a quick reference for setting the switches.
Set the switches appropriately before mounting the camera.
After the camera is installed, you can read the switches from the camera's web interface.
Note
When the camera is not inverted, DIP switches are in their default positions when they are up.
(RoboSHOT 30 HD-SDI shown; Switch 5 is Super Wide Mode if the camera is a RoboSHOT 12 HD-SDI.)
IR1, IR2, IR3 (Frequency Selection):
If there are multiple cameras in the room, use
switches 1 and 2
to
configure each with a different IR frequency to allow the IR Remote Commander to control them
independently. Then use the Camera Select buttons at the top of the remote to select the camera you want
to control.
n
SW1 and SW2 up: IR frequency 1
n
SW1 down, SW2 up: IR frequency 2
n
SW1 up, SW2 down: IR frequency 3
IR:
Leave
switch 3
UP if the IR remote will be used.
Image Flip:
If mounting the camera upside-down, set
switch 4
DOWN: IMAGE FLIP ON.
Super Wide Mode (RoboSHOT 12 HD-SDI only):
To use Super-wide mode, set
switch 5
DOWN. This
gives 12X zoom with a 73º horizontal field of view. Normal mode provides 10X zoom with a 67.2º
horizontal field of view (HFOV).
Baud Rate:
Set
switch 6
to the baud rate of the device connected to the RS-232 port. The default is 9600
bps. The 38400 baud setting is optional if the connected control device supports it.
Leave
Switch 7
UP unless sRGB color output is needed.
For RoboSHOT 30 HD-SDI,
Switch 5
is not used.
Switch 8
is not currently used on either RoboSHOT 12
HD-SDI or RoboSHOT 30 HD-SDI.
11
Complete Manual for RoboSHOT HD-SDI and SDI Professional A/V Presentation Cameras
